1 / 4
LRS-150-24 PSU Cover for AxxSolder — zdjęcie 1
1 / 4

LRS-150-24 PSU Cover for AxxSolder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

LRS-150 cover with separate socket, switch and three-pinned MR60 output connector.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
30
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I needed a compact cover for my LRS-150-24 that would expose the protective earth (PE) pin in addition to the positive and negative terminals so that I could use it with my AxxSolder soldering station. I also wanted to reuse some of the existing C14 sockets and switches I had laying around vs the larger integrated socket-switch of the original design by Fuzebox.

For the connector instead of the XT60 of the original design I decided to use the three-pinned MR60 version. They're cheap and quite beefy not unlike XT60, but the only downside is that I could not find a panel-mount version of it, so had to design for a glued+friction-fit option. This makes the connector pretty much single-use, but nothing to cry about since they do cost about $1.

MR60 connectors can be bought from TME, Amazon or AliExpress (not affliated).

I used a trapezoidal C14 socket and a toggle switch from a broken ATX PSU, so no model number, measure and modify the OpenSCAD design appropriately, if needed.

To connect to AxxSolder a length of flexible SiHF 3x1.5mm2 cable was used + the corresponding connectors.

Additionally two M3x10 flathead screws + rectangular nuts were used to keep the C14 socket in place.

To make the PSU stand vertically there's an excellent design by Tzach.

Tagi