Prusa Advanced Filtration Exhaust Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fits over you filter unit to direct the exhaust to a 100, 80 or 50 mm ID discharge pipe/duct
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 6
- Makes
- 0
- Views
- 87
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is an adapter that fits over the Core One Advance Filtration unit and:
Holds in place with friction, no magnets
Prints without supports
Adapts to a 100mm ID pipe (dryer duct)
Has additional adapters for 50 and 80mm ID pipe/duct.
The 3 corner version is short enough to print on an MK4. The 4 corner version prints on a Core One L. I have printed both in PETG, ABS, PLA during my development phase. The 3 corner works fine and uses less filament. 4 corner is a pretty snug fit. I don't think either if falling off. You can attach with aluminum duct tape if you want. You can leave these on when you change the filter media.
Print with the duct discharge against the bed. I use an 8mm brim on the ID and OD - may print without but hardly seems worth the risk.
You may note the white adapter photo looks different. It is an earlier version but shows that shows a 4 corner unit installed for reference.
I've included two adapters to take this or 80mm or 50mm ID pipe. Full disclosure, I did not test print those as I don't need them for my purposes.
TimeOut@Home https://www.printables.com/model/1544614-core-one-advanced-filtration-exhaust-vent made and exhaust adapter for the Core One Advanced Filtration that attaches with magnets and works pretty well. I did not remix his design, but it served as an inspiration.