Capybara on a Trike — 60 mm Desk Figure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A capybara riding a child's trike, printed as one solid piece.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 4
- Makes
- 0
- Views
- 23
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Standard Digital File License
A capybara riding a child's trike, printed as one solid piece.
No assembly, no glue, no separate wheels. The whole thing — capybara, seat, handlebar, three wheels
— comes off the plate as one part. At 60 % scale it is 41 × 51.7 × 60 mm and about 16 g of PLA:
about two hours of printing for a thing that sits on a monitor stand.
The photos are a real print of this file at 60 % scale, orange PLA, unpainted, straight off the
plate with the supports pulled off.
What is measured, not guessed
- One closed solid — zero open edges, zero non-manifold edges, one connected shell, 199 988
triangles. Nothing to repair before slicing.
- Genuinely solid geometry — 191.2 cm³ of mesh volume, 32 % of its bounding box. A hollowed shell
reads under 5 %; this is a real body that the slicer fills with your infill setting, not a balloon.
- 11.9 % of the surface is past 45°, and past 60° it is 7.8 %. The largest near-horizontal ceiling
on the whole model is 2.5 cm² spanning 20.6 mm at file scale — at 60 % that is 0.9 cm² and a 12 mm
span, 9 mm above the plate. It is the underside of the belly between the wheels.
- It needs supports, and tree (auto) is enough. The head overhangs the handlebar and the wheels
overhang their axles. Build-plate-only is fine — nothing needs a support tower landing on the model
itself.
- Plate contact is 332 mm² in the file, 120 mm² at 60 %. That is three small wheel contacts and a
60 mm tall part above them. Print it with the brim on.
