1 / 3
Capybara on a Trike — 60 mm Desk Figure — zdjęcie 1
1 / 3

Capybara on a Trike — 60 mm Desk Figure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A capybara riding a child's trike, printed as one solid piece.

Ocena
0 / 5
Polubienia
3
Pobrania
4
Wydruki
0
Wyświetlenia
23
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Standard Digital File License

A capybara riding a child's trike, printed as one solid piece.

No assembly, no glue, no separate wheels. The whole thing — capybara, seat, handlebar, three wheels

— comes off the plate as one part. At 60 % scale it is 41 × 51.7 × 60 mm and about 16 g of PLA:

about two hours of printing for a thing that sits on a monitor stand.

The photos are a real print of this file at 60 % scale, orange PLA, unpainted, straight off the

plate with the supports pulled off.

What is measured, not guessed

- One closed solid — zero open edges, zero non-manifold edges, one connected shell, 199 988

triangles. Nothing to repair before slicing.

- Genuinely solid geometry — 191.2 cm³ of mesh volume, 32 % of its bounding box. A hollowed shell

reads under 5 %; this is a real body that the slicer fills with your infill setting, not a balloon.

- 11.9 % of the surface is past 45°, and past 60° it is 7.8 %. The largest near-horizontal ceiling

on the whole model is 2.5 cm² spanning 20.6 mm at file scale — at 60 % that is 0.9 cm² and a 12 mm

span, 9 mm above the plate. It is the underside of the belly between the wheels.

- It needs supports, and tree (auto) is enough. The head overhangs the handlebar and the wheels

overhang their axles. Build-plate-only is fine — nothing needs a support tower landing on the model

itself.

- Plate contact is 332 mm² in the file, 120 mm² at 60 %. That is three small wheel contacts and a

60 mm tall part above them. Print it with the brim on.

Tagi