Nautilus Gears — Print-in-Place Halloween Fidget
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two spiral gears that mesh and turn, printed as one piece. No assembly, no supports, no pins to push in.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 68
- Makes
- 0
- Views
- 217
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Standard Digital File License
Two spiral gears that mesh and turn, printed as one piece. No assembly, no supports, no pins to
push in.
The chambers of a nautilus shell, cut clean through, on two gears that drive each other. Spiders
and bats hide in the cutouts. A bracket over the top holds both gears on their axles — it comes off
the plate already working.
54 × 87 mm, 16.5 mm tall, about 20 g of PLA.
What is measured, not guessed
- Three bodies in one file — two gears and the bracket that caps them — all closed, all in their
final positions, 87 002 triangles.
- Both gears are 7.5 mm thick. The clearance between gear and bracket is 0.323 mm; between the two
gears at the closest point of the mesh, 0.305 mm. Those two numbers are what decide whether it
turns.
- The bracket bridges 36.5 mm. Its top plate is 4.74 cm² of near-horizontal surface starting 10.5
mm above the plate, carried on two feet at the ends. That is the one demanding thing on this print.
- 19.9 % of the surface is past 45°, and 15.3 % of it is dead flat and facing down. There is almost
no sloped overhang here: surfaces are vertical, on the plate, or bridging.
- Plate contact 2 179 mm², across the two gears and the bracket feet.
- Filament: about 20 g at 2 walls and 15 % infill — estimated from the geometry, not read off the
slicer.
