1 / 3
Nautilus Gears — Print-in-Place Halloween Fidget — zdjęcie 1
1 / 3

Nautilus Gears — Print-in-Place Halloween Fidget

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Two spiral gears that mesh and turn, printed as one piece. No assembly, no supports, no pins to push in.

Ocena
0 / 5
Polubienia
7
Pobrania
68
Wydruki
0
Wyświetlenia
217
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Standard Digital File License

Two spiral gears that mesh and turn, printed as one piece. No assembly, no supports, no pins to

push in.

The chambers of a nautilus shell, cut clean through, on two gears that drive each other. Spiders

and bats hide in the cutouts. A bracket over the top holds both gears on their axles — it comes off

the plate already working.

54 × 87 mm, 16.5 mm tall, about 20 g of PLA.

What is measured, not guessed

- Three bodies in one file — two gears and the bracket that caps them — all closed, all in their

final positions, 87 002 triangles.

- Both gears are 7.5 mm thick. The clearance between gear and bracket is 0.323 mm; between the two

gears at the closest point of the mesh, 0.305 mm. Those two numbers are what decide whether it

turns.

- The bracket bridges 36.5 mm. Its top plate is 4.74 cm² of near-horizontal surface starting 10.5

mm above the plate, carried on two feet at the ends. That is the one demanding thing on this print.

- 19.9 % of the surface is past 45°, and 15.3 % of it is dead flat and facing down. There is almost

no sloped overhang here: surfaces are vertical, on the plate, or bridging.

- Plate contact 2 179 mm², across the two gears and the bracket feet.

- Filament: about 20 g at 2 walls and 15 % infill — estimated from the geometry, not read off the

slicer.

Tagi