Elenco AM-550CK AM Radio Kit Housing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A housing for Elenco's AM-550CK AM radio kit to make it a bit more useable than simply the bare board.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 15
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
A housing for Elenco's AM-550CK AM radio kit to make it a bit more useable than simply the bare board. To get it to fit on your print plate, you may need to split it into multiple parts. I split it in half in PrusaSlicer and used the peg connectors by placing two on the faceplate and four around the sides of the radio body in order to fit it on a MK4S for printing.
I then superglued the halves during assembly after lining up the pegs to make the attachment permanent. It accommodates four M3 screws up to 15 mm in length to secure the faceplate into the body. The screws are intended to be threaded directly into the plastic rather than using threaded inserts since it's not a critical fastener.
This model was created using Fusion 360.