Drill Bit Tuning Peg Winder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An adapter that fits over guitar tuning pegs with a 1/4" hex shank, letting you restring with a drill or screwdriver
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 13
- Makes
- 0
- Views
- 31
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial
Restringing by hand is a fine way to build forearm strength you'll never use again. This adapter fits over standard tuning peg buttons and takes a 1/4" hex shank, so your cordless drill or power screwdriver does the winding for you. Slot it on, squeeze the trigger, done — a full six-string change takes seconds.
Prints in one piece. Cheap enough that leaving one in every gig bag is a reasonable life choice.
A word of caution: run your drill on its lowest speed and clutch setting. This is meant to save you time, not help you snap a string or strip a tuner post at 1,200 RPM. Ease off as you approach pitch and finish by hand — tuning is still a human job.
Tuning peg buttons vary more than you'd expect, so check the fit against your own set. Remixes welcome.