Drill Bit Tuning Peg Winder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter that fits over guitar tuning pegs with a 1/4" hex shank, letting you restring with a drill or screwdriver
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial
Restringing by hand is a fine way to build forearm strength you'll never use again. This adapter fits over standard tuning peg buttons and takes a 1/4" hex shank, so your cordless drill or power screwdriver does the winding for you. Slot it on, squeeze the trigger, done — a full six-string change takes seconds.
Prints in one piece. Cheap enough that leaving one in every gig bag is a reasonable life choice.
A word of caution: run your drill on its lowest speed and clutch setting. This is meant to save you time, not help you snap a string or strip a tuner post at 1,200 RPM. Ease off as you approach pitch and finish by hand — tuning is still a human job.
Tuning peg buttons vary more than you'd expect, so check the fit against your own set. Remixes welcome.