Antenna base loading coil (40m amateur radio)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Extend the electrical length of a wire antenna with this base load coil (e.g. a 5.7meter wire for lambda/4 at 7.1MHz)
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 14
- Makes
- 0
- Views
- 115
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Use case
This printed core is to cleanly wind a coil from up to 2mm diameter wire. That wire can be with insulation, like in my case, but thanks to the printed groove, it can also be plain wire.
When fully wound (like in my pictures) it gives around 14uH of inductance at the 40m amateur radio band which is around 7.1MHz. The inductance is slightly frequency dependent, as can be seen in the graph, as it is near its resonance frequency, which is around 12MHz.
I use about 2/3 of the coil, as can be seen in the cover picture, got a 5.7m long vertical wire antenna (held by carbon fiber extension mast) to be nicely resonant at 7.1MHz with sufficient bandwidth to cover the 200kHz wide band (here in Europe, it is from 7.0MHz to 7.2MHz). Of course you need to have sufficient counterpoise for your ground system. I found that two tune radials (10m long each) that do not touch the ground (otherwise they will act as ground loss reduction but not as part of your antenna system) work best for me. To keep them off the ground by half a meter seem to be sufficient.
Versions
There two versions. One is the plain core, which is fine if you simply need a coil core. The more advanced one features screw domes and can be equipped with lids. The bottom lid is to hold a BNC connector and has through holes for the two tuned radials. The top lid come with the through hole for the antenna wire.
Printing
The parts are very easy to print. Simply print them in the uploaded orientation, no supports are needed. I use PETG for all my functional parts, but I would guess that PLA works fine as well. There is not much material inside the coil, so the electrical characteristics of the core should not matter too much.
Assembly
If you use the plain version, simply wind the wire on the core and feed it through the holes to the inner side when done. A cable tie on the inside can help if the wire is trying to slip out of the hole.
For the advanced version you need 4 screws of M3 size, at least 6mm long, it can be 10mm or more if you have. The screws are self-cutting into the screw domes and will hold your lids securely in place.
Details and hints
There a few more holes in the lids, which I used to feed cable ties through to secure the outgoing wires (antenna and counter poise)
The green box below the coil simply holds a common mode choke. I did not trust the tuned radials to perfectly eliminate any common mode signals. If you are at a portable site and noise from nearby electronics is not an issue, just skip that travel lightly
I used the alligator clamp and the soldered little rings to have a means of tuning the antenna on the coil. In the field if that a tap at every 2nd turn is kind of sufficient. If you are a perfectionist, tap it at every turn for a very fine tuning capability.
Happy printing and 73!