MikroTik RouterBOARD Wall/Panel Hanger
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A pair of 3D-printed brackets that let you hang a rack-width MikroTik RouterBOARD below the bottom edge of a vertical bo
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Mounting bracket set for hanging a rack-mount MikroTik RouterBOARD (tested on the RB3011UiAS-RM) from a vertically mounted board or wall panel, so the router hangs just below the panel's lower edge, out of the way, with ports still reachable.
The set is two mirrored parts (left and right, both included in the STL). Each bracket screws directly into the face of the vertical board with two screws, and hooks onto the router's chassis at the side where the factory rack ear normally attaches — so the stock metal rack ears aren't needed at all, the printed brackets do that job.
Features
2 mirrored brackets (left + right) in one STL
Replaces the original rack ears — no extra hardware needed at the router side
Screws into the face of a vertically mounted board/panel
Tested and in use on a MikroTik RB3011UiAS-RM
Dimensions (per bracket): approx. 75 x 24 x 17 mm
[Note: test-fit the screw holes and hook opening against your own board thickness and router chassis before printing a full batch — these were sized for the reporter's specific setup.]