TTArtisan AF 56mm f1.8 Square Hood Lens Cap (snap-in, 2-part)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A snap-in lens cap for the square metal hood that ships with the TTArtisan AF 56mm f1.8. Tested on the Sony variant.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 3
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A snap-in lens cap for the square metal hood that ships with the TTArtisan AF 56mm f1.8. The hood is the same across the Sony E, Fujifilm X and Nikon Z versions of the lens, so this should fit all three. Tested on the E-mount version.
Why?
The TTArtisan hood has a rectangular opening of about 32 x 47.2 mm. No off the shelf lens cap fits it, which means either that the lens stays exposed or that the hood stays in the bag. This cap fixes that. If you have another square hood with an inner lip and a similar opening, it may fit as well (check dimensions above).
Design
Two parts, no hardware, no glue:
Top plate: covers the hood opening, with a raised rim that sits on the hood's front edge so the cap does not wiggle, and an internal rail that guides the spring.
Spring: a linear spring with two guide blocks that ride in the rail and catch behind the hood's lip.
Assembly
Drop the spring into the rail on the underside of the plate. Squeeze the spring, lever the two sides underneath the brides on either end, then firmly push the spring onto the central pin. Done.
Printing
Print both parts flat as oriented, supports onle needed on build plate.
Material used: PETG
Layer height: 0.2 mm
Walls: 6 walls at 0.46 mm line width
Infill: 15% gyroid infill
Top layers: 4 at 0.8mm thickness
Bottom layers: 4
Support: Tree, buildplate only
Threshold angle 30%