Badminton Racket and Birdie/shuttlecock Holder Wall Mount PARAMETRIC
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Badminton Racket wall mount
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 0
- Makes
- 0
- Views
- 28
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Wanted to make a sleek mount for my badminton rackets so that I could mount them to the wall.
THERE ARE 2 MODELS INCLUDED. One version includes a shuttlecock holder.
Customization:
The rackets that I have have 7 mm diameter stems. I have included the Blender file if you wish to change the dimensions to match your racket. TO MODIFY THE ROD THICKNESS, go into the modifiers tab and change the rod thickness value using the geometry node, THEN PRESS APPLY.
The rackets were 3d scanned in a stable position using my Metro X scanner and then cleaned up and modelled in Blender.
INSTRUCTIONS:
Mount to the wall using a roughly M3-sized screw of your choosing. The head diameter has to be less than 5.5mm and less than 2.5mm thick for it to fit easily. You can change this in the blend file under the MOUNTING HOLE MODEL.
Print in the following orientation. Recommend that you print with 2 walls or else it might be hard to attach and remove. If you are having trouble inserting you can always shave a little bit off with a knife. The first few times that it snaps in will be hard but it should creep in. You can assit it in the first time with a heat gun or blow dryer if you are having trouble.

Not for commercial use. Remixes allowed
