Lift Platform for Meijer 5 Gallon Dispensor Jug
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A custom designed block to make a specific jug of water higher
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 10
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Share Alike
This platform is shaped specifically to securely cradle the 5 gallon dispensor jug sold by midwestern retailer Meijer, potentially others. Engages with the ribs so the jug cannot move separately from the platform
Specifically for the purpose of lifting a jug of distilled water high enough to dispense into the water tank of a Resmed Airsense 10 CPAP.
There are 3 files, the platform itself and two test pieces. If you are unsure that this will fit your particular jug, print the test pieces and check, that is their only purpose.
Filament type doesn't matter, go cheap or pretty.
You should enable variable layer height to reduce print time, almost all of the layers are purely vertical. You could also use a fixed very tall layer height if you don't care about it looking a little worse at the top.
Use 2 perimeters total however your slicer splits that up. Use 5~15% infill in a pattern that varies on the Z axis to stitch the walls together well. I used 10% TPMS-FK and it worked well.
This is not a hyper-optimized design, it takes a while to print and uses a goodly chunk of filament. I made it this way to satisfy my own whims.