1 / 4
Lift Platform for Meijer 5 Gallon Dispensor Jug — zdjęcie 1
1 / 4

Lift Platform for Meijer 5 Gallon Dispensor Jug

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A custom designed block to make a specific jug of water higher

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
10
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This platform is shaped specifically to securely cradle the 5 gallon dispensor jug sold by midwestern retailer Meijer, potentially others. Engages with the ribs so the jug cannot move separately from the platform

Specifically for the purpose of lifting a jug of distilled water high enough to dispense into the water tank of a Resmed Airsense 10 CPAP.

There are 3 files, the platform itself and two test pieces. If you are unsure that this will fit your particular jug, print the test pieces and check, that is their only purpose.

Filament type doesn't matter, go cheap or pretty.

You should enable variable layer height to reduce print time, almost all of the layers are purely vertical. You could also use a fixed very tall layer height if you don't care about it looking a little worse at the top.

Use 2 perimeters total however your slicer splits that up. Use 5~15% infill in a pattern that varies on the Z axis to stitch the walls together well. I used 10% TPMS-FK and it worked well.

This is not a hyper-optimized design, it takes a while to print and uses a goodly chunk of filament. I made it  this way to satisfy my own whims.

Tagi