Quick-release plate for strap
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€5.91 – €7.23 net (excluding VAT)
For file: Quick-release plate for strap.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €6.57 excluding VAT (range midpoint).
- Weight reported by the author
- 38 g
- Print time reported by the author
- 8 hr
- Source material
- ABS
- Estimate material
- ABS
- Estimate printer
- Bambu Lab X1 Carbon - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Spring-loaded quick-release plate with locking pin and rotating dial — attach and detach a strap in seconds
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 4
- Makes
- 0
- Views
- 103
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
Quick-Release Plate for Strap
A 3D-printable quick-release plate that lets you attach and detach a strap (camera, bag, tool, etc.) in one motion, without screws or tools. The mechanism uses a spring-loaded locking pin and a rotating dial to lock and release the strap connector securely, while two side buttons allow for quick manual release.
PRINT SETTINGS
Material: ABS or PETG recommended (better durability and heat resistance than PLA for a mechanism under constant tension)
Layer height: 0.12mm
No supports needed for most parts (check orientation per part)
Print all parts x1, EXCEPT the "pin" and "button" parts, which need to be printed x2
HARDWARE NEEDED
4x M3x35mm screws (assemble the main mechanism)
M3 screws for mounting to the back plate/strap — length depends on the thickness of the surface you're attaching it to
1x standard pen spring (the small spring found inside a regular ballpoint pen) — cut in half, and place one half in each locking mechanism compartment
ASSEMBLY NOTES
Insert the cut spring halves into the pin compartments before closing the housing
The M3x35mm screws hold the top and bottom housing together
Mounting screw length will vary depending on your attachment surface — measure before ordering/cutting screws
Feel free to leave a comment if you have questions about assembly or want to see it in action!