1 / 4
EGPU enclosure for ADT-Link F9G oculink board — image 1
1 / 4

EGPU enclosure for ADT-Link F9G oculink board

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a housing for a GPU, an ADT-Link F9G oculink board, and a SFX PSU.

Rating
0 / 5
Likes
1
Downloads
22
Makes
0
Views
210
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial

This is a remix of this model, but it is slightly taller.

To make your own oculink EGPU you need:

  • An ADT-Link F9G oculink board (aliexpress, ~30€)

  • Oculink cable (aliexpress, ~20€)

  • SFX PSU (50-100€)

  • A graphics card

  • A couple of screws

Instructions:

  1. (optional) glue 8 magnets in to the two parts of the enclosure. Make sure they are facing the right way so they keep the enclosure closed

  2. Carefully destroy the sleeve of the 24 pin ATX cable on one side

  3. Plug that side of the 24 pin ATX cable in to the F9G board

  4. Screw the F9G board in to the enclosure

  5. Plug a PCIE power cable in to your GPU

  6. Plug the GPU in to the F9G board

  7. Screw the GPU IO in to the enclosure

  8. Screw the PSU in to the enclosure

  9. Connect all the cables, and use your EGPU

Step 2 is kind of necessary since there is almost no space for the 24-pin ATX cable going in to the F9G board. I made it work by cutting the sleeving off the cable bundle.

From my own testing the GPU I used ran very cool because it is essentially in the open air, and it isn't stuck inside a warm box with lots of other components. Also I used a 1m long oculink cable which caused issues. Apparently longer cables cause signal issues so I recommend using a 50cm cable.

AI was used because I suck at 3D modelling. I have actually printed this model and tested that it works. I used fuzzy skin on the outside because I think it looks nicer. I used PLA and thusfar it seems to hold up. But I recommend printing in PETG because hot air from the GPU might deform the enclosure.

This is made from PascalB_CH’s original work, thanks for everything!

Tags