EGPU enclosure for ADT-Link F9G oculink board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a housing for a GPU, an ADT-Link F9G oculink board, and a SFX PSU.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 210
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix of this model, but it is slightly taller.
To make your own oculink EGPU you need:
An ADT-Link F9G oculink board (aliexpress, ~30€)
Oculink cable (aliexpress, ~20€)
SFX PSU (50-100€)
A graphics card
A couple of screws
Instructions:
(optional) glue 8 magnets in to the two parts of the enclosure. Make sure they are facing the right way so they keep the enclosure closed
Carefully destroy the sleeve of the 24 pin ATX cable on one side
Plug that side of the 24 pin ATX cable in to the F9G board
Screw the F9G board in to the enclosure
Plug a PCIE power cable in to your GPU
Plug the GPU in to the F9G board
Screw the GPU IO in to the enclosure
Screw the PSU in to the enclosure
Connect all the cables, and use your EGPU
Step 2 is kind of necessary since there is almost no space for the 24-pin ATX cable going in to the F9G board. I made it work by cutting the sleeving off the cable bundle.
From my own testing the GPU I used ran very cool because it is essentially in the open air, and it isn't stuck inside a warm box with lots of other components. Also I used a 1m long oculink cable which caused issues. Apparently longer cables cause signal issues so I recommend using a 50cm cable.
AI was used because I suck at 3D modelling. I have actually printed this model and tested that it works. I used fuzzy skin on the outside because I think it looks nicer. I used PLA and thusfar it seems to hold up. But I recommend printing in PETG because hot air from the GPU might deform the enclosure.
This is made from PascalB_CH’s original work, thanks for everything!