Winkelanschlag Miter Fence Metabo Führungsschiene
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Winkelanschlag (45° und 90°) für Metabo Kreissägen-Führungsschienen Angle Guide (45° and 90° ) for Metabo guide rails
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 18
- Makes
- 0
- Views
- 89
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
English below.
Dieser Winkelanschlag passt auf Metabo Führungsschienen für Kreissägen und harmoniert gut mit der kurzen FS 80. Auf diese Länge halte ich ihn für ausreichend genau. Mit dem blauen 30 cm Winkel (siehe Fotos) habe ich zumindest keine Abweichung feststellen können.
Lange Schnitte mit einer FS 160/250 sollte man natürlich nicht damit durchführen, ohne noch einmal nachzumessen. Irgendwann wird es sicherlich etwas auseinanderlaufen.
Es gibt drei Montagepositionen: 90°, 45° nach links, 45° nach rechts.
Es gibt zwei Versionen des Einschubs für die Schiene. Einmal für Einschmelzgewinde M4, 8 mm lang und einmal für M4-Muttern. Besser ist das Einschmelzgewinde, aber für Leute, die keine haben, habe ich noch eine Version für M4-Muttern erstellt. Am besten die Muttern dann einkleben. Ansonsten braucht man nur zwei M4x20-Sechskantschrauben.
Wunder dich nicht, dass die Löcher alle verschlossen sind in den STLs. Das ist Absicht, damit die Brücken schöner drucken und nur 0,2 mm dick. Einfach mit einem Bohrer durchstoßen.
English:
This angle guide, miter fence or whatever it's called in english fits Metabo rails like the FS 80/160. It has one 90° and two 45° degree positions, see photos.
It works very well with the shorter FS 80 rail. Of course, you should not use this to try to cut an exact 90 degree angle with a 250 rail. But for everything that can be cut with the 80 rail, it is very usable.
You need two m4 heat set inserts and two M4x20 hex head screws. If you do not have M4 heat sets, you can use the alternative file for M4 nuts, but you should glue in the nut
Don't worry, that the holes are all closed in the STLs. That is intentional to achieve better bridging and only 0.2 mm thick. Just push it out with a drill bit.