Billie Eilish . Lamp
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
LED lamp inspired by Billie Eilish's logo.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 33
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Billie Eilish . LED Lamp
Hi everyone! I present a 3D model of a lamp inspired by the iconic logo of singer Billie Eilish . It’s a great project for Billie fans and lovers of atmospheric interior lighting.
The model consists of a three-dimensional figure/logo and a base with the text "Billie Eilish". An LED strip can easily be installed inside the body, allowing you to change the backlight color with a remote (as shown in the photo).
Recommended Print Settings:
Material: PLA (perfect for decorative lamps).
Layer Height: 0.2 mm (for better light diffusion, 0.12–0.16 mm can be used).
Perimeters/Shells: 2–3.
Infill: 15–20%.
Supports: Not required if the model is printed in the correct orientation (front panel flat).
Required Components (Electronics):
LED strip .
Controller for LED strip with IR remote (as in the photo) or smart controller (e.g., WLED).
Power supply (depending on strip length).
Assembly Instructions:
1. Print all parts of the model.
2. Cut the required length of LED strip. Glue it to the inner wall of the back panel or the lamp base using double-sided tape or hot glue.
3. Solder wires to the strip and connect them to the controller.
4. Connect the front panel with the back panel using glue.
5. Connect power and enjoy the color changes!
Notes:
I printed this model at 120% scale.
Make sure wires are not pinched when assembling the housing.
If you use a powerful strip, make sure the plastic does not heat up too much (this is critical for PLA; it is better to use low-power strips or provide ventilation).
I would love to see your prints in the "Makes" section! Don’t forget to share photos.