Ruckus Ceiling Mount Retrofit for 1-gang Low Voltage Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 2-piece ceiling mount to retrofit a low-voltage bracket for stronger support of a Ruckus wireless access point.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 39
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A 2-part ceiling mount / drywall clamp to more strongly support a wireless access point on a ceiling.
Can be installed as a retrofit through an existing 1-gang metal low voltage bracket.
Uses captive M4 nuts and M4 bolts to clamp against the sheetrock for a strong and stable mount.
Compatible with Ruckus R510 and Ruckus R750 at least - likely many other Ruckus models, but these are the only two I have to test with.
Backstory
I recently purchased a pair of Ruckus R750 wireless access points to replace some older wifi 5 R510 devices in my house. The house was pre-wired with 1-gang low voltage bracket ceiling mounts for Wifi access points, but unfortunately they were a rather thin steel without enough rigidity to stand up to the long screws the electricians used for the R510s. As a result I found it extremely difficult to install the R750 in their place without bending the screws out of the way when trying to fit them into the keyholes. Once I did manage to fit the keyholes, the heavier weight the R750 bent the bracket relative to the truss and drywall, hanging it off level.
Out of frustration, I modeled this replacement.
Printing
PETG
0.2mm STRUCTURAL profile for Core ONE L
3 perimeters, 25% infill
No supports needed, print with the flat sides to the bed.
Assembly / Installation
Materials
Both printed pieces - bottom faceplate and top box
4x M4 hex nuts
4x M4 bolts - I used 30mm for my sheetrock
Instructions
Insert M4 hex nuts into the slots of the top box
Thread any cables through the opening in the top box, turn the top box at an angle, and insert through hole or existing bracket into ceiling.
Reorient top box with arms supporting against drywall/existing bracket, and holes downward
Thread any cables through the faceplate and loosely attach it with the inner two M4 bolts to the top box. These will form the clamp, but don't tighten them yet.
Align the assembly with existing screw holes for the low voltage bracket (if any), and start the outer two M4 bolts through the faceplate, the existing bracket and then into the top box. Leave appropriate protrusion for your keyhole mounts.
Tighten the inner / clamp bolts to pull the halves toward one another and lock the mount in place.
Adjust outer keyhole bolts to appropriate depth and install device.