1 / 2
2.42" OLED housing for Amiga floppy emulator (Gotek, Flashfloppy, OpenFlops) — image 1
1 / 2

2.42" OLED housing for Amiga floppy emulator (Gotek, Flashfloppy, OpenFlops)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Housing for a Waveshare 2.42" OLED, Fits an Amiga 600 or 1200.

Rating
0 / 5
Likes
0
Downloads
7
Makes
0
Views
55
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Public Domain

A fairly minimal and low-profile housing for a larger-then-usual OLED screen for your Amiga floppy emulator.

Specifically created for the Waveshare "2.42inch OLED Display Module, 128×64 Resolution, SPI / I2C Communication"

You'll need to use a small amount of hot glue or similar to hold the screen in place, but the print itself should friction-fit fairly tightly into the grille of the A600/1200.

The thin/thick variants are just differences in bezel thickness, particularly over the lower part of the screen. The thin version is best if printing in dark colours, the slightly thicker version is better for light colours (otherwise it's a bit translucent and you can see the black edge of the screen quite visibly)

For the print in the photos, Sunlu 'bone white' matte PLA was used, which is a reasonable-ish color match, better than pure white at least. Depends how yellowed your Amiga case is, I suppose.

(If you sometimes get a corrupted display with this screen, make sure DC and CS are connected to GND, and a 10K resistor between RST and VCC, and a 10uF capacitor between RST and GND)

Tags