Extremely Rugged Screw-Together Phone Case for Samsung Galaxy A52 (PLA, M2 or M3 screws)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Very rugged 2-part Galaxy A52 case for PLA. No TPU needed, screwed together with 6 M2 or M3 screws
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 9
- Makes
- 0
- Views
- 83
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Open Community License v1.1 + General Attribution v1
Most phone cases on Printables are designed for TPU. I didn't have any, so I made a rugged case for the Samsung Galaxy A52 that prints in PLA instead.
How it works
Since PLA isn't flexible enough to snap around the phone, the case is a two-part shell that is screwed together around it. The phone isn't held by snap-fits, so it sits securely and there's no stress on the plastic while you're putting it on or taking it off.
Two versions included
M3 version for M3 screws (Buy M2 Screws and Washers)
M2 version for M2 screws (Buy M3 Screws)
What you need
6 screws per case (M2 or M3, depending on the version you print)
Screw length: between 5 mm and 14 mm
Washers are recommended for the M2 version. M2 screws have small heads, which means a low contact area against the plastic. A washer spreads the load and keeps the heads from pulling through.
Printing tips
Material: PLA (PETG should also work)
Print the parts in the orientation provided in the files
Use enough walls and infill for the rugged feel, more walls matter more than infill for impact strength
Notes
Designed for the Samsung Galaxy A52. It may not fit the A52 5G or A52s exactly, so check the dimensions first if you have one of those.