Ryobi LINK Small Bin | Stronger 4 mm Walls and Flat Bottom
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Ryobi LINK small bin with thicker 4 mm walls and floor for added strength, a flat base, and the original mounting clea
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 24
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
This is a stronger, flat-bottom remix of “Small Bin for Ryobi Link” by RobC. I removed the four small feet under the original bin and increased the nominal walls and floor from 2 mm to 4 mm. The added material goes toward the inside, so the exterior and rear LINK mounting cleat retain their shape. The tradeoff is slightly less room inside the bin.
I made this revision after two PETG prints of the thinner bin developed splits. The thicker design is intended to improve durability, but this revision has not yet been print tested. If your prints split along layer lines, check your PETG temperature and cooling settings as well.
Print the STL upright with its flat base on the bed. Check your slicer preview for support needed under the rear LINK cleat. Slice this modified STL yourself; G-code for the original model will print the earlier geometry.
Original bin: “Small Bin for Ryobi Link” by RobC, based on “Cleat for Ryobi Link” by SemaphoreSlim. Shared under RobC’s CC BY-NC 4.0 license.