Actiq Combat Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two-lollipop Actiq case with a push-button latch and a tethered hinged lid. Tuned for Bambu Lab A1 in PETG HF.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 31
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Medical Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A case that holds two Actiq lollipops, with a push-button latch and a tethered hinged lid. Tuned for Bambu Lab A1 in PETG HF.
Print settings
Filament: Bambu PETG HF (official profile)
Nozzle / layer height: 0.4 mm / 0.2 mm
Walls: 4
Infill: 25% Gyroid
Supports: not required
Build plate: Textured PEI (use glue stick on Smooth PEI)
Body: print upright, bottom on the plate. Lid: print upside down, top face on the plate (files are already oriented). The 3MF has both parts on one plate, ready for Bambu Studio.
Assembly
Cut a 23 mm piece of 1.75 mm filament and push it through all three hinge knuckles. It's a snug fit in the body and turns freely in the lid.
Optionally, lightly melt the pin ends to lock the pin in place.
Close the lid until it clicks. To open, press the button and lift.
Customization
The OpenSCAD source is included. CLR sets the general clearance (0.25; raise to 0.3 if parts are too tight), CATCH_R sets the latch depth (lower it, e.g. to 19.7, if the button is too stiff), and LABEL sets the text engraved on the lid.