Multi Color Calibrator - Cheap and Fast Spiral Vase
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cheap and fast multi color calibrator using spiral vase mode for a 1 wall, no fill tester in 7 mins.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 6
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Just a simple, cheap, and fast calibrator for multi color filaments. I've been using several round calibration tools, but it was difficult to determine how that gradient would transfer to flat surfaces (like boxes). So just made one with many sides. 45 degree increments, which is fine enough for my work, with a hole marking zero.
Print details
7 mins
1 perimeter (spiral vase)
2 bottom layers
no fill
How to use
Load up your filament and print the calibrator. Be sure spiral vase is on!
Clear the print bed in your slicer, then load up your desired model and print settings.
With calibrator in hand, rotate the model in you slicer so that desired colors on calibrator match where they will print on model.
Print.