dji mic holder and recorder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cad design for holding an endeavour en10 (mp3 player) and dji mic mini 2's
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Public Domain
Cad design for holding an endeavour en10 (mp3 player) and dji mic mini 2's. the mics clip onto the top of this design and when needed can easily clip onto a shirt or hat. the receiver stays in on the holder and connects the mics wirelessly to the mp3 recorder. we can also play music from the mp3 player
supports are included in the design so this model should print well on many prints, (setup time after printing is less than 10 minutes. remove all the supports easily and give the corners a light sand with 100+ grit sand paper, as they can print quite sharp due to the supports.
slide the en10 mp3 recorder into the main housing and then slide the receiver mount into the back of the main housing, this should be quite tight as to not come out in use. plug the jack cable from the receiver to the mp3 recorder and you're good to go!
extra:
this case also includes a 1/4 20 tripod mount, so it can be mounted easily along side cameras.
this case also includes a 0.35cm through hole to mount a wrist strap if you want
cad editing file if you wish to copy this file and make your own
https://cad.onshape.com/documents/b036dfffde85d1f07827b9fc/w/16794cfcdfc7098cf0dccb0d/e/1cf65e5057869e6e91336b2c