Desk Edge Cable Organizer Clip - 3 Snap-In Cable Channels, No Supports (18 / 25 mm)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clip for the desk edge that holds 3 charging cables in snap-in channels. No screws, no supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 23
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Standard Digital File License
Stop charging cables from sliding off the back of your desk. This clip slides onto the desk edge and holds up to three cables in snap-in channels. The plug stays on the desk and the cable hangs neatly over the edge.
Snap-in channels: 5.2 mm round channel with a 2.8 mm angled entry. Push the cable in from the top and it clicks into place. Fits most USB-C, Lightning and micro-USB cables (about 3–5 mm).
Tool-free mounting: the lower jaw converges by 0.8 mm, so the clip grips the desk without screws or tape.
Two sizes: for 18 mm desks (chipboard, plywood) and 25 mm desks. Measure your desk top before printing.
Strong: it prints on its side, so the jaws flex along the layers instead of across them.
Solid body, 38 mm wide, rounded edges, chamfered sides.
Print settings
Orientation: as supplied (lying on its side). No supports, no brim.
0.20 mm layer, 3 walls, 15% infill. PLA or PETG (PETG gives a slightly springier grip).
Time on Bambu Lab A1 with PLA at 0.20: 18 mm – 36 min / 10.5 g; 25 mm – 37 min / 11.4 g.
Tip: if the clip is loose on your desk, print the smaller size. If it is too tight, warm the lower jaw briefly with a hair dryer and open it a little.
Designed from scratch by bezbajzlu.