IKEA SKÅDIS Adapter for Modular Toploader Wall Display
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
One-piece SKÅDIS adapter for the Modular Toploader Wall Display. Fits existing slots without modifying the holder.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 27
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
## IKEA SKÅDIS Adapter for Modular Toploader Wall Display
Mount your Modular Toploader Wall Display vertically on an IKEA SKÅDIS pegboard with this separate, one-piece adapter.
Two connector feet fit into the holder’s existing upper slots. A continuous rail runs across the upper short edge, and two integrated rear hooks attach the assembly to the pegboard.
The original holder requires no modifications, screws or glue.
### Compatible holder
This download contains the adapter only. Download the compatible holder separately:
- [Original holder on Printables](https://www.printables.com/model/1864229-modular-toploader-wall-display-support-free-design)
- [Original holder on Thingiverse](https://www.thingiverse.com/thing:7417663)
### Features
- One-piece adapter
- Fits the existing upper connector slots
- Full-width rail across the upper short edge
- Two integrated SKÅDIS hooks
- Vertical display orientation
- Trimmed design without the raised front extension
- No modifications to the original holder
### Assembly
1. Insert your toploader into the holder.
2. Fit the adapter’s two connector feet into the upper connector slots.
3. Seat the adapter against the holder.
4. Insert the rear hooks into the SKÅDIS slots and lower the assembly into place.
Print one adapter per holder.
### Suggested print settings
These are starting settings and have not yet been validated by a physical print:
- Layer height: 0.20 mm
- Perimeters: 4
- Infill: 25–35%
- Material: PLA or PETG
Check the hook overhangs in your slicer and enable supports where needed. Support-free printing has not been confirmed.
### Included file
SKADIS_Toploader_Adapter_ohne_Ueberstand.stl
### Prototype status
Untested prototype. The STL has been checked for closed mesh geometry. Physical connector fit, SKÅDIS fit and load capacity have not yet been tested.
### Design process
Created as a custom adapter based on the original holder’s connector geometry and designed specifically for mounting the holder on IKEA SKÅDIS pegboards.
Designed for IKEA SKÅDIS. Not affiliated with or endorsed by IKEA.