drying/annealing basket for the Elegoo H1 HT

This is a remix of Calcifer's silica gel/annealing basket 

Modifications :

• I scaled it to fit the H1 HT better (it was a bit loose)

• I made it reversible so you can turn it around because the heat comes only from one side

• I made it work together with my latch seal model 

• I made it print in two parts to avoid using any supports

• I increased the holding capacity a bit

• I made it fit my neptune 4's small build plate (225x225 mm)

Print settings :

• use a high temperature resistant material (at least 95°C/203°F, I used Elegoo ASA)

• the large top part needs a brim or huge mouse ears; the bottom part doesn't need it

• use a 0.6/0.8 nozzle (if you have one), otherwise it might take a long time

Assembly : 

Just glue the two parts together.