Garden Chair Slider Feet extension / Gartenstuhl Gleiter bzw. Füße inkl. Erhöhung
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modells are used to either just replace worn out feet from Aldi garden chairs. Or to extend their height.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 16
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
Hello,
I really like my old aluminum Aldi garden chairs. They are now about 15 years old and still going strong. Just the plastic feet are worn down. And getting a new garden table I would like to have them 2cm heigher than before.
So I build some custom feet to be 3D printed. They'll suite to all alu chairs with the following pipe diameters.
Sizes:
Rear 24mm round
Front 45x25 elliptic
5,10,20,30mm height (see model name)
Printing:
use tough filament suitable for outdoor. PETG as a minimum
have at least 4 outer layers
have at least 7 bottom layers (this will wear down)
use gyroid infill with 25%
you need to print 2 front and 2 rear feet (with the same height)
neither support nor brim needed.
Hope someone else has a use for this as well.