1 / 5
Garden Chair Slider Feet extension / Gartenstuhl Gleiter bzw. Füße inkl. Erhöhung — zdjęcie 1
1 / 5

Garden Chair Slider Feet extension / Gartenstuhl Gleiter bzw. Füße inkl. Erhöhung

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modells are used to either just replace worn out feet from Aldi garden chairs. Or to extend their height.

Ocena
0 / 5
Polubienia
1
Pobrania
1
Wydruki
0
Wyświetlenia
16
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Hello,

I really like my old aluminum Aldi garden chairs. They are now about 15 years old and still going strong. Just the plastic feet are worn down. And getting a new garden table I would like to have them 2cm heigher than before.

So I build some custom feet to be 3D printed. They'll suite to all alu chairs with the following pipe diameters.

Sizes:

  • Rear 24mm round

  • Front 45x25 elliptic

  • 5,10,20,30mm height (see model name)

Printing:

  • use tough filament suitable for outdoor. PETG as a minimum

  • have at least 4 outer layers

  • have at least 7 bottom layers (this will wear down)

  • use gyroid infill with 25%

  • you need to print 2 front and 2 rear feet (with the same height)

  • neither support nor brim needed.

Hope someone else has a use for this as well.

Tagi