Core One INDX spool mounting plates, keeping left side storage usable

Core One + Gen2 INDX   4 Tool - 6 Tool - 8 Tool   spool mounting plates with integrated puck and numbering, leaving the left side storage usable.

Variants available:

• Standard mount 4 Tool or 8 Tool holdingplates (left or/and right side storage occupied)

• 4 Tool high mount (left and right side storage accessible)

• 6 Tool right mount (left side storage accessible)

• 8 Tool high and right mount (left side storage accessible) 

The spool holders feature an integrated "puck" (no need to screw it on). Numbering is included for easy identification of each tool. The mounting holes are designed to use M3x12 or M3x12rT Screws. The holders are specifically designed to allow the use of a Prusa CSS Drybox at every position.

Note: For stability reasons, it is recommended to use 2 kg spools only on the lower right mounts (due to the three mounting points).

Printing recommendation:

• 0.4 nozzle

• 0.2mm balanced

• 3 perimeters

• 3d-honeycomb or gyroid infill

• no supports

Please refer to the original mounting instructions for the middle and bottom spool holder plates.

For the top spool holders, remove the two screws (green) and the two rivets (orange), then mount the spool holders with M3x12 or M3x12rT screws, on the rivet position use M3nN nuts on the inside of the frame.

An adapted filament path solution is available to optimize the filament paths (see picture below). The filament sensors will be on the back (yellow) with no flying cable on the outside of the printer. Two adapters (blue) for optimizing the input hight to the printer cover.

PTFE tube endpoints are available here (see picture below).