10″ 1U Rack Mount — Raspberry Pi 5 + NVMe & TP-Link LS1005G

This mount combines a Raspberry Pi 5 and a TP-Link LS1005G in a single 1U panel for a 10-inch rack.

The Pi has individual openings for Ethernet and both USB banks. The switch uses an opening for its complete front panel.

The design includes:

• A 3 mm thick front panel.

• Reinforced cradles with triangular gussets.

• Open sides and ventilation slots.

• Removable rear stops.

• Recesses for the screw heads beneath the Pi’s NVMe assembly.

• 6.2 mm rack mounting holes.

• Vertically aligned Raspberry Pi and switch Ethernet port centres.

Compatibility:

Designed around these assemblies:

• Raspberry Pi 5 with the GeeekPi Armor case and CN01 NVMe adapter: approximately 58 × 32 × 89 mm.

• TP-Link LS1005G: approximately 90 × 25 × 72 mm, including its feet.

This is a mount for these specific configurations. Other Raspberry Pi cases, NVMe adapters or switch revisions may require changes.

The panel measures 254 mm wide × 43.5 mm high, with an overall depth of approximately 92.4 mm.

Included files:

1. RPI5 TPLink.stl
   Print one main panel with integrated cradles.

2. RPI stop alternative switch stop x2.stl
   Print two for the Raspberry Pi.
   This stop can also be used as an alternative for the switch if a different front position is preferred.

3. Switch stop flush mount x2.stl
   Print two for the switch’s flush mounting arrangement.

For the standard configuration, print one main panel, two Pi stops and two flush-mount switch stops.

Printing:

All three STL files load in their intended print orientation. The main panel prints with its front face flat on the build plate and the cradles extending upwards.

Suggested starting settings:

• PETG.

• 0.4 mm nozzle.

• 0.2 mm layer height.

• 5 walls.

• 5 top and bottom layers.

• 30% gyroid infill.

• A brim if needed for bed adhesion.

The ventilation openings have angled ends to reduce unsupported spans in this orientation.

Assembly:

Use one M3 × 12 mm screw per rear stop: four screws in total for the standard arrangement.

The stop holes provide clearance for M3 screws. The cradle rails have 2.5 mm pilot holes intended to be tapped M3. Tighten gently to avoid damaging the plastic threads.

Use suitable rack screws and washers for your rack.