1090 MHz ADSB Ground Plane Antenna Hub for SO239 / N Chassis Sockets (parametric)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A hub for building a quarter wave ground plane antenna for 1090 MHz ADSB from a square flange SO239 or N chassis socket.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 9
- Makes
- 0
- Views
- 61
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A hub for building the classic quarter wave ground plane antenna for 1090 MHz ADSB from a square flange SO239 or N chassis socket and some stiff copper wire.
The socket bolts to a small top plate with M3 screws and nuts. You screw the coax plug onto the socket in the open, then drop the plate into the hub with the plug going down the bore, so there's no fiddling with a plug inside a tube. Four radials run from the flange holes and snap into grooves on the 45 degree shoulder, so they all sit at the same angle and stay there. A slotted collar fits a 25 mm mast and a hose clip pulls it tight. The radome drops over the vertical element and locates on a ring, with notches where the radials pass.
The ZIP also has a cut gauge. Lay the wire in the channel against the stop and snip it flush with the end. That gives you the vertical and the radials at length, with a bit extra for the solder cup and the screw loop. At 1090 MHz that's 65.3 mm for the vertical and 72.2 mm for the radials, which are the usual starting figures and close to what other builders use. They aren't tuned on an analyser.
Print the fit coupon first. It checks your mast, the flange hole spacing, the nut pockets and three groove sizes in a few minutes. It's worth doing, because some N sockets use a wider hole spacing than the usual 18.2 mm.
The OpenSCAD source is included. Frequency, wire size, hole spacing, mast size and radial angle are all settings. Every part prints without supports. Use PETG or ASA outdoors, as PLA won't last in the sun.
If you print one, I'd love to see it. Post a make with a photo, good or bad, and it helps me improve the next version.
Happy to tweak the design on request.