Ezurio Vela IF820 DVK bottom case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Low-profile bottom case for the Ezurio Vela IF820 dev board, with M3 nut pockets and a slot for a TC2030 clip.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 7
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
A 5.6 mm tall bottom case for the Ezurio Vela IF820 development board (453-00171-K1). The board sits on the floor with its top face flush with the rim.
Four M3 screws through the board's mounting holes, with M3 nuts pressed into hex pockets from below.
USB notch with flared ends, so the cable plugs in with the board seated.
The space under the board is solid, apart from pockets for the header pins that stick out underneath and a shallow recess for the label on the board's underside.
A slot under the TC2030 footprint lets a Tag-Connect TC2030-CLIP reach the board from below while it sits in the case.
The OpenSCAD source is included. fit sets the clearance around the board.
Hardware: 4× M3 screws, 4× M3 nuts.