Bondtech BMG on MK3S+ / MK3.5 with Prusa Chimney for MMU3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I couldn't find MMU adapter for the MMU3 + Bondtech BMG combo that would work reliably. So I adapted the Prusa design
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 1
- Makes
- 0
- Views
- 51
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- GNU General Public License v2.0
There are other Bondtech BMG + MMU adapters out there. I tried two of them. Neither was reliable for me. None of them cited explicit compatibility with the MMU3 either, but I believe the chimney design is basically the same for the MMU2S. The design that bondtech points to works OK, but the chimney has some play in it which results in false readings on the IR sensor. Originally I thought I would add an extra bolt hole that would lock the chimney down in place so it would be rigid, but then I realized that Prusa's stock design already does this, so I decided to pivot to just adapting the stock design.
Prusa doesn't provide the STEP files for the MMU3 printed parts (I even asked support!), so I had to reverse-engineer them using the STL files.
This design stays mostly true to the original prusa design with some changes. The main issue that needed fixing is that the idler door on stock has the pivot point for above the filament gears, while on the BMG, the pivot point is below the filament gears. This means that when the filament enters the gears on the stock design, the IR sensor flag on the idler door pivots into the chimney, while on the BMG, the IR sensor flag pivots out of the chimney.
Design Notes
You'll need to replace the idler door with the custom one that will work with the chimney.
The IR sensor flag on the door is thin and delicate, under nominal circumstances, that's not a problem since it doesn't come into contact with anything. However you should be careful when assembling, especially since the idler door is a pain to replace.
An additional bolt hole was added to clamp the chimney base to the adapter insert for the BMG.
This is to prevent the base and chimney from pivoting because otherwise it would only have one mounting point.
A new hole was added to the chimney to give the ir sensor flag more space on the other side of the filament sensor, this is to accommodate the fact that the flag moves to opposite way as stock when filament enters the gears
The bottom of the chimney base is thinner than on stock to account for the extra height of sitting on top of the extruder rather then in the insert area. Together this is no taller than the other chimney design bondtech links too.
You'll need the regular prusa parts
M3x30 + washer for the chimney adjustment
one square M3 nut for the chimney
M2 bolt for the IR sensor
M3x18 for the chimney set screw
In addition, you'll need.
M3x10 bolt + M3 heat set insert for the insert as noted about
