Little Tikes Ride on Horse and similar replacement wheel rod cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Little Tikes use a simple rod and friction fit washers with a plastic end cover. this is a replacement end cap
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 0
- Makes
- 0
- Views
- 16
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
We acquired a Little Tikes sit and ride on horse toy. Unfortunately the front wheels were missing their protective covers for the ends of the rod used for the axel. I knocked up this simple and quick design in Tinkercad to replace the missing covers. They are printed in TPU and took approx 11-12 mins to rpint the two parts.
This was on and Ender 3 V2 running Klipper and direct drive extruder. o.4 nozzle and 0.2 layer height with 50% infill. The centre holes are sized to be slightly smaller than the rod diameter to make them a tight friction fit.
Print in the model orientation to avoid supports. If using a PEI plate or similar, they grip fine. Otherwise you might need a small brim to help them grip to your build plate.