Stepped Hex Bit Holder - 24 x 1/4 inch Bits, Customizable Rows (OpenSCAD)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Three stepped rows of snug hex sockets for 1/4 inch screwdriver bits. Change rows, count and fit in OpenSCAD.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 13
- Makes
- 0
- Views
- 41
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A desk or workbench block for your screwdriver bits: three rows of eight snug hex sockets, each row standing 6 mm higher than the one in front, so you can see every bit tip and grab the one you need.
The sockets are 6.6 mm across the flats for standard 1/4 inch (6.35 mm) hex bits and 10 mm deep, with a small chamfer so bits drop straight in. A flat of each hexagon faces the front, so the bits line up neatly. Size: about 82 x 32 x 24 mm.
Make it yours: open the .scad file in OpenSCAD (free), go to Window > Customizer, and change the bits per row, the number of rows, the step height, the spacing, the depth and the fit. If your printer makes holes tight, raise the hole size to 6.7 or 6.8.
Print settings: PLA or PETG, 0.2 mm layers, 15% infill, no supports. It prints flat as shown. On a Bambu Lab H2C it takes about 58 minutes and 23 g. A ready plate (the H2C .3mf) is included.
Designed with AI assistance, checked and sliced by me. License: CC BY-NC-SA 4.0.