Steam Frame Hackstrap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This was originally posted on MakerWorld but it got taken down for unknown reasons by the original maker.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 31
- Makes
- 0
- Views
- 268
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Attribution — Noncommercial
I highly recommend printing everything in TPU as the slip needs a little bit of flex, and having the locking key for the strap have some flex to it makes it WAY more comfortable and conforming to your hand.
To install this, remove battery door and put the locking key into the respective controller. Put one slip onto each strap past the sizing tabs, it might take a little force. Grab the battery door, and insert the large notch in the strap at the thin section onto the pointy section of the battery door until it is past the locking tab so it holds it in place (look at the second photo for a better idea). Make sure the sizing tabs on the printed grip are facing outward from your hand for the most comfort. Loop the strap into the locking key, and using the sizing tabs find a size that works for your hand. Opt for tighter than you would think. Once that is sized, move the slip as close to the locking key as possible to remove any slack in the strap. Voila! DIY ergo grips for the steam frame controllers!