Circular Saw Dust Extraction Adapter (39mm to 34mm Tapered)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tapered dust collection adapter to connect a circular saw port to shop vac hoses. 39mm to 34mm transition optimized.
- Rating
- 5 / 5
- Likes
- 3
- Downloads
- 9
- Makes
- 1
- Views
- 35
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A direct, functional conical adapter designed to bridge the gap between circular saw dust extraction ports and standard shop vacuum / dust extractor hoses.
The tapered geometry relies on a tight friction fit (interference fit), eliminating the need for hose clamps in typical workshop setups while maintaining positive pressure and suction seal.
Critical Dimensions
Large End: 39 mm Outer Diameter (OD)
Small End: 34 mm Outer Diameter (OD)
Internal Geometry: Smooth, continuous conical bore designed to minimize turbulence, pressure drop, and clogging from larger wood chips.
Material Selection
Recommended: PETG (or ABS / ASA).
Why not PLA? PETG provides the necessary impact resistance, layer adhesion, and slight mechanical compliance required to press-fit firmly against tool vibration without cracking or suffering from creep over time.
Print Settings & Slicer Recommendations
Orientation: Print vertically, seated on the 39 mm base for maximum bed adhesion. No supports required.
Perimeters / Walls: 3 to 4 minimum (Crucial: the mechanical strength and hoop stress resistance come from perimeter count, not infill).
Infill: 20% – 30% (Gyroid or Cubic).
Layer Height: 0.25 mm (0.28 mm works fine if you want a faster functional print).
Seam Position: Aligned or Rear (prevents internal bumps that could catch fine sawdust).
Brim: Optional, only if your bed adhesion is marginal.