1 / 2
Circular Saw Dust Extraction Adapter (39mm to 34mm Tapered) — zdjęcie 1
1 / 2

Circular Saw Dust Extraction Adapter (39mm to 34mm Tapered)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Wstępna wycena dla PETG

1,23 € – 1,50 € netto (bez VAT)

Dla pliku: Adaptador aspiradora a Sierra Circular_0.4n_0.25mm_PETG_COREONE_1h1m.bgcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 1,36 € netto (środek widełek).

Masa podana przez autora
26 g
Czas druku podany przez autora
1,02 godz.
Materiał u źródła
PET
Materiał wyceny
PETG
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Tapered dust collection adapter to connect a circular saw port to shop vac hoses. 39mm to 34mm transition optimized.

Ocena
5 / 5
Polubienia
3
Pobrania
9
Wydruki
1
Wyświetlenia
35
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A direct, functional conical adapter designed to bridge the gap between circular saw dust extraction ports and standard shop vacuum / dust extractor hoses.

The tapered geometry relies on a tight friction fit (interference fit), eliminating the need for hose clamps in typical workshop setups while maintaining positive pressure and suction seal.

Critical Dimensions

  • Large End: 39 mm Outer Diameter (OD)

  • Small End: 34 mm Outer Diameter (OD)

  • Internal Geometry: Smooth, continuous conical bore designed to minimize turbulence, pressure drop, and clogging from larger wood chips.

Material Selection

  • Recommended: PETG (or ABS / ASA).

  • Why not PLA? PETG provides the necessary impact resistance, layer adhesion, and slight mechanical compliance required to press-fit firmly against tool vibration without cracking or suffering from creep over time.

Print Settings & Slicer Recommendations

  • Orientation: Print vertically, seated on the 39 mm base for maximum bed adhesion. No supports required.

  • Perimeters / Walls: 3 to 4 minimum (Crucial: the mechanical strength and hoop stress resistance come from perimeter count, not infill).

  • Infill: 20% – 30% (Gyroid or Cubic).

  • Layer Height: 0.25 mm (0.28 mm works fine if you want a faster functional print).

  • Seam Position: Aligned or Rear (prevents internal bumps that could catch fine sawdust).

  • Brim: Optional, only if your bed adhesion is marginal.

Tagi