Japandi Shower Caddy with Hidden Razor Drawer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Japandi wall shower caddy: ribbed tray with drains, hidden razor drawer and two hooks. Tape or hidden screw mount.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 83
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A minimal japandi shower shelf for the tiled wall: a ribbed tray for bottles, a hidden drawer for two razors and two hooks for a sponge and a brush. Printed in PETG on a Bambu Lab P1S and hanging in my shower now.
Features
Ribbed tray with drain slots at both ends
Hidden drawer with a click stop and a perforated floor
Two hooks, angled slightly upwards
Two bases: plain back for tape, or two hidden countersunk holes for 4 mm screws behind the drawer
No supports, 5 mm brim on every plate
Dimensions
Assembled: 232 x 95 x 92 mm (W x D x H)
Back plate: 230 x 138 mm
Tray inside: about 224 x 88 mm, 53 mm deep
Drawer inside: about 164 x 78 x 33 mm (razors up to about 150 mm long)
Print settings
PETG, 0.4 mm nozzle, 0.20 mm layers, 4 walls, 15 % gyroid, no supports, 5 mm brim, Textured PEI. Tested on a Bambu Lab P1S. The Bambu Studio project (.3mf) has four named plates with these settings.
Plate | Contents | Time | Filament |
|---|---|---|---|
1 Tray | tray.stl | 5 h 44 min | 183 g |
2 Base (tape) | base.stl, plain back | 3 h 28 min | 121 g |
3 Base (screws) | base_screws.stl, two screw holes | 3 h 32 min | 121 g |
4 Drawer, discs, hooks | drawer.stl, 4x key.stl, 2x peg.stl | 3 h 8 min | 93 g |
Assembly
Put the four discs in the pockets on top of the base.
Glue the tray onto the base along the whole seam with a glue suited for PETG.
Glue the hooks into their holes.
Slide the drawer in from the front, with a firm push past the click.
Mounting
Tape: clean the tile, spread waterproof strips evenly over the back, and test with a load for 24 hours before use.
Screws: two 4 mm countersunk screws with wall plugs, fitted through the drawer opening with the drawer removed.
Version 1 (tape base) is the one in the photos. The screw base is new in version 2 and has not been printed yet.