1 / 8
Japandi Shower Caddy with Hidden Razor Drawer — zdjęcie 1
1 / 8

Japandi Shower Caddy with Hidden Razor Drawer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Japandi wall shower caddy: ribbed tray with drains, hidden razor drawer and two hooks. Tape or hidden screw mount.

Ocena
0 / 5
Polubienia
1
Pobrania
8
Wydruki
0
Wyświetlenia
83
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A minimal japandi shower shelf for the tiled wall: a ribbed tray for bottles, a hidden drawer for two razors and two hooks for a sponge and a brush. Printed in PETG on a Bambu Lab P1S and hanging in my shower now.

Features

  • Ribbed tray with drain slots at both ends

  • Hidden drawer with a click stop and a perforated floor

  • Two hooks, angled slightly upwards

  • Two bases: plain back for tape, or two hidden countersunk holes for 4 mm screws behind the drawer

  • No supports, 5 mm brim on every plate

Dimensions

  • Assembled: 232 x 95 x 92 mm (W x D x H)

  • Back plate: 230 x 138 mm

  • Tray inside: about 224 x 88 mm, 53 mm deep

  • Drawer inside: about 164 x 78 x 33 mm (razors up to about 150 mm long)

Print settings

PETG, 0.4 mm nozzle, 0.20 mm layers, 4 walls, 15 % gyroid, no supports, 5 mm brim, Textured PEI. Tested on a Bambu Lab P1S. The Bambu Studio project (.3mf) has four named plates with these settings.

Plate

Contents

Time

Filament

1 Tray

tray.stl

5 h 44 min

183 g

2 Base (tape)

base.stl, plain back

3 h 28 min

121 g

3 Base (screws)

base_screws.stl, two screw holes

3 h 32 min

121 g

4 Drawer, discs, hooks

drawer.stl, 4x key.stl, 2x peg.stl

3 h 8 min

93 g

Assembly

  1. Put the four discs in the pockets on top of the base.

  2. Glue the tray onto the base along the whole seam with a glue suited for PETG.

  3. Glue the hooks into their holes.

  4. Slide the drawer in from the front, with a firm push past the click.

Mounting

  • Tape: clean the tile, spread waterproof strips evenly over the back, and test with a load for 24 hours before use.

  • Screws: two 4 mm countersunk screws with wall plugs, fitted through the drawer opening with the drawer removed.

Version 1 (tape base) is the one in the photos. The screw base is new in version 2 and has not been printed yet.

Tagi