1 / 11
Power Meter Magnetic case for ESP32-2424S012 (1.28" round display) with charging stand — image 1
1 / 11

Power Meter Magnetic case for ESP32-2424S012 (1.28" round display) with charging stand

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A round case for the **ESP32-2424S012** board (ESP32-C3 with a 1.28" round touch display), with hexagon accents

Rating
0 / 5
Likes
2
Downloads
25
Makes
0
Views
151
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Public Domain

Features

  • Two interchangeable screw-on back covers:

    • USB cover: low profile, 18.7 mm total thickness, for always-plugged-in use.

    • Battery cover: with a chamber for an 802530 LiPo (~500–600 mAh), 24.7 mm total thickness.

  • Invisible magnets: they sit behind 0.6 mm of plastic, so no glue shows.

    • In the cover, the magnet press-fits between 3 radial ribs. It's centered, so it works however the cover ends up rotated.

    • In the stand, the magnet slides in edge-first through a side slot. A flexible latch holds it by pressing on its flat face, never on its edge. An ejector hole lets you push it out with a pin.

  • Industrial-style stand:

    • Hexagonal plinth with an engraved honeycomb pattern, and a hexagonal backplate that stays hidden behind the display.

    • V-jaws, like a machinist's V-block, that center the case.

    • Honeycomb cells cut all the way through.

  • Ballast from 4 M8 nuts (DIN 934, 22 g) that slot in from underneath.

  • Cable exit through a rear tunnel. A regular straight USB-C cable works.

  • A side hole lets you reach the slide switch with a toothpick.

  • No supports needed: the STLs are already oriented for printing.

What you need

  • 1 × ESP32-2424S012 board

  • 2 × neodymium magnets, Ø11.7 × 1.7 mm (measured; look for 12 × 2 mm)

  • 4 × M8 DIN 934 nuts (ballast)

  • Optional: 1S 802530 LiPo battery with a protection circuit and a 1.25 mm JST connector (not the 2.0 mm JST-PH)

  • Optional: superglue, adhesive silicone bumpers

Print settings

  • Layer height 0.2 mm or lower, 3 perimeters.

  • Stand: 15–20 % infill.

  • PLA is fine for the USB version.

I The photos were taken without the ballast, which is why the stand moves so easily. My battery hasn't arrived yet, so the battery cover's measurements might be slightly off; I'll update it once it arrives. If anyone wants the ESPHome YAML code, just send me a message.

Tags