1 / 2
Drill Guide - Drill Straight 90 Degree Holes by Hand, 3-10 mm, with V-Groove for Dowels (OpenSCAD) — image 1
1 / 2

Drill Guide - Drill Straight 90 Degree Holes by Hand, 3-10 mm, with V-Groove for Dowels (OpenSCAD)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A drilling jig for straight, square holes by hand: six guide holes from 3 to 10 mm and a V-groove for round stock.

Rating
0 / 5
Likes
1
Downloads
11
Makes
0
Views
43
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

Drill straight, square holes without a pillar drill. Hold the block flat on the work, pick the hole for your bit and drill through it: the 30 mm guide keeps the bit at 90 degrees. The 90-degree V-groove underneath centres the block on dowels, pipes and broom handles, so you can drill straight through the middle of round stock too.

DETAILS

• 92 x 40 x 30 mm with guide holes for 3, 4, 5, 6, 8 and 10 mm bits, each with its size engraved and a small countersink to start the bit.

• Centre-line notches on both ends line up with a pencil mark.

• Prints with no supports: the guide holes go straight down and the V-groove has 45-degree sides.

• Bambu Studio: 1 h 5, 34 g. Use 4+ walls so the holes stay true, and check your bits slide in (raise the clearance if not).

CUSTOMIZE (OpenSCAD)

Bit sizes, hole clearance and guide height.

Tags