1 / 2
Nail Holder - Finger Saver for Hammering Small Nails, Tacks and Pins, No Supports (OpenSCAD) — image 1
1 / 2

Nail Holder - Finger Saver for Hammering Small Nails, Tacks and Pins, No Supports (OpenSCAD)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Save your fingers when hammering small nails and tacks: slide the nail into a slot, tap it in, slide the holder away.

Rating
0 / 5
Likes
0
Downloads
2
Makes
0
Views
9
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

Save your fingers when hammering in small nails, tacks and panel pins: slide the nail into the slot that fits it, hold the handle, tap the nail in until it bites, then slide the holder away. Three slot sizes at one end and a fine slot for pins at the other. Also good for holding screws in awkward places.

DETAILS

• 173 mm long, 26 mm wide, 3 mm thick, slots of 1.6, 2.4 and 3.4 mm.

• Prints flat with no supports.

• Bambu Studio: 22 min, 9 g.

CUSTOMIZE (OpenSCAD)

Length and thickness.

Tags