RJC Wall Organizing System - Modular
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
One Organizer. Unlimited Possibilities.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 13
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Stop buying organizers. Start building one. The RJC Wall Organizer is a modular wall system — stack the bands, then drop accessories in from the top. Designed by my AI, printed while I slept. Printed, fitted, and tortured until every click felt right — so you don't have to.
This is the foundation everything else hangs on. Three band variants (top, middle, bottom) stack vertically into any height you need. My own build grew from these bands into a full 3×3 grid — nine bands, mounted on my shop wall and loaded with accessories.
How accessories mount: the click-fit drop-in system. Every accessory carries v4.3 mount posts (5.6mm stem, Ø12.5mm tapered head). Drop the accessory in through the Ø14mm entry holes, slide it down 40mm, and it seats with a solid friction click. Removing one is just as easy — lift and out. Rearrange your whole wall in minutes without touching a screwdriver.
What's in this listing:
- Top Band v3 (240×120×10mm) — 4 mount slots (Ø14mm entry holes, 6mm wide slots, 40mm slide travel), caps the top of your stack
- Middle Band v3 (240×120×10mm) — same slots, grooves top and bottom so stacks keep growing; print as many as you need
- Bottom Band v3 (240×120×10mm) — finishes the bottom of the stack
Want the full grid? The splines (join bands vertically AND side-by-side) and the end caps (the picture-frame finish) live in the companion listing: RJC Wall Organizing System — Complete System. Same bands, plus everything that turns a stack into a framed grid like mine.
Specs:
- Band: 240×120×10mm
- Slot grid: 48mm spacing, 4 slots per band
- Post interface: v4.3 (5.6mm stem, Ø12.5mm tapered head, 7.10mm total protrusion)
Compatibility: every accessory in the RJC Wall Organizer System mounts to these bands — mail holder, key hooks, pen holders, shelf, and everything still coming. If it says RJC Wall Organizer, it fits.
Printing suggestions:
- Orientation: pre-oriented, print as-is (band face flat on the bed)
- Supports: none needed
- Brim: recommended — these are large flat parts and bed adhesion matters. (I learned this the hard way: clean plate, glue, brim.)
- Layer height: 0.2mm standard; 0.28mm if you want it done faster
- Walls/infill: 3 walls, 15–20% infill is plenty
Material: PETG recommended — wall-mounted parts take daily handling; PETG holds up. PLA prints fine too if that's what you have.