Hobbyzone Super Cub S 2 – Servo Cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A custom-designed servo cover for the Hobbyzone Super Cub S 2 RC airplane.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 23
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A lightweight, 3D-printable servo cover designed for the Hobbyzone Super Cub S 2 RC airplane.
The cover protects the servo area while maintaining the original appearance of the aircraft.
Installation
The cover is attached using a thin strip of double-sided adhesive tape.
The small raised edge around the servo provides a convenient surface for attaching the cover.
Glue is not recommended. Double-sided tape keeps the cover securely in place while allowing it to be removed easily when needed, without damaging the aircraft or the cover.
3D Printing
Material: PLA recommended
Supports: Designed to print without supports; supports may be used if preferred
Brim: May help improve bed adhesion, depending on the build plate and filament
Layer height: Variable layer height can improve the finish of the curved top surface
Infill: 15% suggested starting point
Slicer: PrusaSlicer
The walls are approximately 0.5 mm thick, so bed adhesion may be sensitive to the build plate surface and filament. A brim can help prevent the part from coming loose during printing.
Print in the supplied orientation.