Hobbyzone Super Cub S 2 – Servo Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A custom-designed servo cover for the Hobbyzone Super Cub S 2 RC airplane.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A lightweight, 3D-printable servo cover designed for the Hobbyzone Super Cub S 2 RC airplane.
The cover protects the servo area while maintaining the original appearance of the aircraft.
Installation
The cover is attached using a thin strip of double-sided adhesive tape.
The small raised edge around the servo provides a convenient surface for attaching the cover.
Glue is not recommended. Double-sided tape keeps the cover securely in place while allowing it to be removed easily when needed, without damaging the aircraft or the cover.
3D Printing
Material: PLA recommended
Supports: Designed to print without supports; supports may be used if preferred
Brim: May help improve bed adhesion, depending on the build plate and filament
Layer height: Variable layer height can improve the finish of the curved top surface
Infill: 15% suggested starting point
Slicer: PrusaSlicer
The walls are approximately 0.5 mm thick, so bed adhesion may be sensitive to the build plate surface and filament. A brim can help prevent the part from coming loose during printing.
Print in the supplied orientation.